Contact us

Email: sichip209@gmail.com
Skype: techip.mcu.01
Tel:15313166209
QQ:1002668449

Take code from mcu M30280FCHP

时间:2017-11-22 17:17:11 click:nums

My company can take code from mcu M30280fchp, If you need to decrypt the chip, or PCB copy, please contact us, Skype: techip.mcu.01  Email: sichip209@gmail.com

One of the attack technologies: invasiva attacks

Despite to more complexity of invasive attacks some of them could be done without using expensive laboratory equipment. Low-budget attackers are likely to get a cheaper solution on the second-hand market for semiconductor test equipment. With patience and skill it should not be too difficult to assemble all the required tools for even under ten thousand US dollars by buying a second-hand microscope and using self-designed micropositioners. The laser is not essential for first results, because vibrations in the probing needle can also be used to break holes into passivation.

Invasive attacks start with the removal of the chip package. Plastic over the chip could be removed by knife. Epoxy resin around the chip could be removed using fuming nitric acid. Hot fuming nitric acid dissolves the package without affecting the chip. The procedure should preferably be carried out under very dry conditions, as the presence of water could corrode exposed aluminium interconnects. The chip is then washed with acetone in an ultrasonic bath, followed optionally by a short bath in deionized water and isopropanol. After that chip could be glued into a test package and bonded manually. Having enough experience it might be possible to remove epoxy without destroying bonding wires and smartcard contacts.

Once the chip is opened it is possible to perform probing or modifying attacks. The most important tool for invasive attacks is a microprobing workstation. Its major component is a special optical microscope with a working distance of at least 8 mm between the chip surface and the objective lens. On a stable platform around a socket for the test package, we install several micropositioners , which allow us to move a probe arm with submicrometer precision over a chip surface. On this arm, we install a probe needle. These elastic probe hairs allow us to establish electrical contact with on-chip bus lines without damaging them.

 

previous:HD6432148SV reverse engineering next:Break protect of chip PIC16F1575