Contact us

Email: sichip209@gmail.com
Skype: techip.mcu.01
Tel:15313166209
QQ:1002668449

LPC11U12FHN33 mcu attack

时间:2018-10-09 17:46:28 click:nums

LPC11U12FHN33
8/16 kB on-chip SRAM.
64/128/256 kB on-chip flash program memory. 128-bit wide interface/accelerator enables high speed 60 MHz operation.
In-System Programming (ISP) and In-Application Programming (IAP) via on-chip bootloader software. Flash programming takes 1 ms per 512 B line. Single sector or full chip erase takes 400 ms.
EmbeddedICE-RT interface enables breakpoints and watch points. Interrupt service routines can continue to execute while the foreground task is debugged with the on-chip RealMonitor software.
Embedded Trace Macrocell (ETM) enables non-intrusive high speed real-time tracing of instruction execution.
Two interconnected CAN interfaces (one for LPC2109) with advanced acceptance filters.
Four-channel 10-bit A/D converter with conversion time as low as 2.44 μs.
Multiple serial interfaces including two UARTs (16C550), Fast I2C-bus (400 kbit/s) and two SPIs.
60 MHz maximum CPU clock available from programmable on-chip Phase-Locked Loop with settling time of 100 μs.
Vectored Interrupt Controller with configurable priorities and vector addresses.
Two 32-bit timers (with four capture and four compare channels), PWM unit (six outputs), Real-Time Clock (RTC) and watchdog.
Up to forty-six 5 V tolerant general purpose I/O pins. Up to nine edge or level sensitive external interrupt pins available.
On-chip crystal oscillator with an operating range of 1 MHz to 30 MHz.
Two low power modes, Idle and Power-down.
Processor wake-up from Power-down mode via external interrupt.
Individual enable/disable of peripheral functions for power optimization.
Dual power supply:
CPU operating voltage range of 1.65 V to 1.95 V (1.8 V ± 0.15 V).
I/O power supply range of 3.0 V to 3.6 V (3.3 V ± 10 %) with 5 V tolerant I/O pads.

previous:HD6432639 reverse engineering next:Extract mcu LPC2142 HEX or BIN file